Concrete Cure & Seal

CONCRETE CURE & SEAL is a waterborne acrylic emulsion designed to cure, seal, harden and dustproof new or older concrete substrates.
When applied after finishing, Concrete Cure & Seal forms a membrane which retains mix water, allowing normal hydration helping to eliminate scaling of concrete.

USES and ADVANTAGES
• Cures, seals, hardens and dust proofs concrete substrates.
• Dries to a clear, gloss finish.
• Helps to eliminate scaling of concrete.
• An excellent anti-spalling compound.
• Contains no filler, extenders, waxes or flammable solvents.
• Does not blush.
• Non-yellowing.
• UV resistant.
• Helps to prevent against efflorescence.
• Protects against many oils, acids, salt, alkalis, fungus, grease, spalling and damage from sudden rainfalls.
• Retards the moisture exchange giving additional protection for tile, paint and carpet.
• Protects aluminum, copper and steel from concrete stains.
• VOC compliant.
• Meets ASTM-C-309 Type 1, Clear
• Meets Federal Specification TT -C-800A

APPLICATION
Apply with spray equipment, brush, long nap roller or lambs wool applicator. Ordinary garden type sprayers with neoprene hoses are recommended for best results. Spray uniformly to form a continuous film.

Curing New Concrete
Application should be made immediately after finishing as soon as bleed water had disappeared and slab can support the weight of an applicator.
Sealing New Concrete
For an excellent sealer and added protection to concrete cured with product, apply a second coat after 28 days of curing. If not previously applied when curing concrete, two coats are required to properly seal. Second coat to be applied four hours after the first coat. The area to be sealed must be clean and free of all foreign matter (see SURFACE PREPARATION). Apply at a rate of 300-400 square feet per gallon.
Dustproof/Sealing Aged Concrete
The area to be dust proofed/sealed must be clean and free of all foreign matter (see SURFACE PREPARATION).
Apply at a rate of 300-400 square feet per gallon depending on the porosity. Apply a second coat for maximum protection at 300-600 square feet per gallon.

COVERAGE
Please note coverages will vary depending on texture and porosity of concrete surface.
Steel Troweled Concrete
ASTM C-309:
200 square feet per gallon
Federal Specification TT-C-800A:
200 square feet per gallon
Broom Finished Concrete
ASTM C-309:
100 square feet per gallon.
Federal Specification TT-C-800A:
100 square feet per gallon
DRYING TIME
At 80 degrees F:
Dry to touch……………….….30 minutes
Light foot traffic…………………..4 hours
Normal traffic…………………..Overnight
Maximum hardness………..……..7 days